IXXAT Driver Installation for MPI-2 & MPI-3 | BUDS Diagnostic Setup
To establish reliable communication between BUDS diagnostic software and the vehicle ECU, correct installation of the IXXAT CAN driver is required. MPI-2 and M…
Open guideDiagnostic Equipment
To establish reliable communication between BUDS diagnostic software and the vehicle ECU, correct installation of the IXXAT CAN driver is required. MPI-2 and MPI-3 diagnostic adapters use modern USB CAN communication protocols and require dedicated VCI drivers to function properly.
This guide explains how to install the IXXAT driver and prepare your computer for stable BRP diagnostics, firmware programming and ECU recovery procedures.
BRP BUDS Compatibility Chart – MPI-2 / MPI-3 Diagnostic Communication Guide
Official BRP diagnostic compatibility chart showing supported vehicle platforms, communication protocols, and required MPI-2 / MPI-3 interfaces for correct BUD…
Open guideMPI-3 Diagnostic Interface Card – Technical Service Bulletin
This technical service bulletin explains the introduction of the MPI-3 diagnostic interface card designed to replace the earlier MPI-2 interface used for BRP v…
Open guideBRP CAN Bus System and Diagnostics Guide (Controller Area Network)
Technical guide explaining BRP CAN bus system operation, module communication and troubleshooting common CAN network faults using BUDS2.
Open guide