Can-Am Canyon VSS Calibration Update (BUDS3) – Bulletin 2026-4
Official BRP bulletin for Can-Am Canyon (MY2025+) covering Vehicle Stability System (VSS) calibration update using BUDS3, including tools, update procedure, and warranty claim details.
Manual content
Overview
This manual explains how to perform the VSS calibration update on Can-Am Canyon vehicles using BUDS3, based on official BRP bulletin 2026-4.
Includes required tools, step-by-step instructions, and warranty claim information.
🔧 Canyon Vehicle Stability System (VSS) Calibration Update
Bulletin: 2026-4
Date: April 14, 2026
This bulletin describes the procedure for updating the Vehicle Stability System (VSS) calibration on Can-Am Canyon vehicles.
📌 Applicability
- Model: Can-Am Canyon
- Model Year: MY2025 and newer
⚠️ Problem
The VSS calibration has been updated to improve performance under certain riding conditions.
✅ Solution
Update the VSS calibration using BUDS3.
🛠️ Required Tools
- BUDS3 V800 VCI (P/N 529036613)
- V800 VCI Cable Adapter (P/N 529036614)
🚀 Update Procedure
- Install BUDS3 version 1.32.000 or newer
- Connect vehicle using V800 VCI
- Open "Vehicle Update"
- Perform VSS Calibration Update
- Follow on-screen instructions
- Run rescan after update
- Verify software release date
⚙️ Post-Update Steps
- Reset Steering Angle Sensor (SAS)
- Reset Longitudinal Offset
Important:
- Vehicle must be on flat surface
- Perform key OFF / ON cycle between procedures
💰 Warranty
- Labor time: 0.3 hour
- Expiration: April 30, 2030
💡 Required Software
This procedure requires BUDS3 diagnostic software and compatible interface.